B&G Zeus2 Glass Helm CPU - Manual (Page 18)

Basic operation
Turning the system on and off
You turn the system on by pressing the Power key on the front of the processor, or by
pressing the Power key on the ZC1.
You turn the system off by pressing the Power key, or by selecting the Power option on the
Home page or in the System controls dialog.
If the Power key is released before the shut-down is completed, the power off process is
cancelled.
Ú Note: If the unit is configured as a slave you can not power off the unit by the Power key,
and the System controls dialog will not display the power off option.
If a ZM series monitor is configured as power master, you can switch off the power to the
system by pressing the Power key on the monitor. See details in the monitor manual and in
the Zeus
2 Processor Installation manual.
First time startup
The first time the unit is started and after a master reset the system will run through an
automatic start-up sequence, including language setup and automatic data source selection.
You can select to interrupt this sequence and later configure the system yourself.
Standby mode
In Standby mode, the backlight for screen and keys are turned off to save power. The system
will continue to run in the background.
You select Standby mode from the System controls dialog.
Switch from Standby mode to normal operation by a short press on the Power key on the
monitor, on the ZC1 or on the processor.
Display illumination
The display backlighting can be adjusted at any time from the System controls dialog. You
can also cycle the preset backlight levels by short presses on the Power key.
The night mode option optimizes the color palette for low light conditions.
Ú Note: Details on the chart may be less visible when the Night mode is selected!
Locking the touch screen
You can temporarily lock a touch screen to prevent accidental operation of the system. This
feature is also useful when cleaning the screen while the unit is turned on.
You can only lock the touch screen if there is a ZC1 connected on the network to prevent
permanent lock-out.
The touch screen is locked from the System controls dialog.
You remove the lock function by a short press on the Power key on the ZC1.
2
18 Basic operation | Zeus 2 Glass Helm