B&G Zeus2 Glass Helm CPU - Manual (Page 58)

Response
By default the system switches between HI/LO parameter set based on speed (motor boats)
or speed and wind (sail boats). You can however manually select which parameter set that
shall be used.
HI or LO must be selected if no speed input is available.
You can manually fine tune each of the two (HI/LO) parameter sets. Level 4 is default with
parameter values as set by the autotune function. If no autotune is made (not
recommended) the level 4 values are the factory default values.
A low response level reduces the rudder activity and provides a more “loose” steering.
A high response level increases the rudder activity and provides a more “tight” steering. A too
high response level will make the boat start S-ing.
Automatic steering
This option displays an overview of all autopilot steering parameters, and you can adjust
parameters if required.
For more details, refer to the separate Zeus
2 Glass Helm Installation manual.
Installation
Used for autopilot installation and commissioning. See the separate Zeus 2 Glass Helm
Installation manual.
58 Autopilot | Zeus 2 Glass Helm