BE Pressure supply 80 Gallon Enclosed Rotary Screw Compressor AC1080SQ - Manual (Page 28)

28
ALWAYS MAKE SURE POWER IS OFF
BEFORE WIRING COMPRESSOR
1
2
3
Remove panels
and electrical cover
Place 1 of the
incoming power
lines under the
starter screw
shown
Place 2nd incoming
power wire in position 2
on compressor motor
contact
Place 2nd
incoming
power wire in
position 2
on compressor
motor contact
Place ground wire
under washer
4
Put cover back on electric panel before checking for proper rotation. If
rotation is incorrect swap wires in position 1 & 3 to change the rotation.
Once rotation is correct place all panels back on compressor
Place incoming power
wires through wiring
port on the bottom of
the unit
compressor diagram