Carlo Gavazzi WM3-96 - Manual (Page 10)

11
▲ ▲
Displaying of the variables
Harmonic analysis CT ratio
9 15
7 12
Alarms
(A1-A2-A3-A4).
Diagnostics
(D1-D2-D3-D4).
Pulse outputs
(P1-P2-P3-P4).
Digital inputs.
❑
Page “27” (14 in single phase mode)
Displaying of instrument configuration
key disabled. Page 27 shows the configuration of the main
input (IN) and output (OUT) modules.
The letters and numbers between parenthesis are referred to
the relevant slot, while the text on their right shows the variable
referred to the output. With reference to the digital inputs
(DIG.INP.), the ON/OFF status of each one of them is shown.
❑
Displaying with access to the Pass Code
❑
Pass "1000": displaying of recorded events
(Only if the RS232+RTC module is present)
Press the key: when the instrument asks you for the pass
code , set the value "1000"; if the RS232+RTC
module is present, the instrument shows you the page where
the events are displayed and where the instrument stores, in
a chronological order, the alarms that have occurred until that
moment. To go back to the variable page press the
key.
The last event has always the number 1 while the number
corresponding to the first event varies, depending on the
number of events that have been previously stored. The figure
on the following page explains you the meaning of the dis-
played information.