Carlo Gavazzi WM3-96 - Manual (Page 30)

31
▲ ▲
DIAGNOSTIC OUTPUT, REMOTE
CONTROL OUTPUT. To enter these
functions, choose DIGITAL OUTPUT
from the main menu using the
and
keys, then confirm with . The
instrument shows a window where the
various slots (OUT C0, OUT C1, etc.)
and output channels (1, 2, etc.) are shown. Select the desired
slot using the
and keys and confirm with to enter
the output function menu (if the module is not in the slot, the
instrument displays NOT AVAILABLE). To reset the choices and
go back to the main menu, press
.
The meaning of the symbols on the display is the
following:
OUT C0 (1): digital output, SLOT C0, channel 1
OUT C1 (2): digital output, SLOT C1, channel 2
OUT D0 (3): digital output, SLOT D0, channel 3
OUT D1 (4): digital output, SLOT D1, channel 4
❑
Pulse output
This function allows the user to set
the parameters of the pulse output.
The output can be connected to a
specific energy and this energy can
be connected to the desired tariff.
The measured energy is re-trans-
mitted by means of the pulse output
(the pulses/energy ratio of which is
programmable). Use
and to
select PULSES from the list of avail-
able outputs; then confirm with
and choose from the submenu
ENERGY TYPE the energy that you
want to be retransmitted, using
and :
1.2..
..2.1
Display of harmonics
29
29 37
Analogue outputs
35
Outputs / Other settings