4 adjusting the belt alignment and running – Dick SM-140 UltraSharp 230V User Manual
Page 18
Advertising
Belt grinder SM-140
18
Putting into operation
7
The distance [2] between the deflection plate [1] and the polishing
wheel [3] must not exceed 2 mm.
1 Undo the knurled nut [4],
2 Adjust the distance [2],
3 Tighten the knurled nut [4].
7.4
Adjusting the belt alignment and running
DAMAGE TO THE BELT GRINDER DUE TO SKEW STARTING
UP OF THE GRINDING BELT!
A misaligned, skew-running belt damages the housing.
• Before switching on the belt grinder, check the running of the
grinding belt, to ensure it is straight.
Figure 7.3 – Adjusting device
[1] Deflection pulley
[2] Tensioning lever
[3] Belt tensioner
[4] Knurled adjusting screw
[5] Knurled lock nut
5
1
4
2
3
Advertising