2 changing the grinding belt – Dick SM-140 UltraSharp 230V User Manual
Page 30
Advertising
Belt grinder SM-140
30
Servicing and maintenance
9
1 Remove and clean the water tank,
2 Undo the fastening screws and remove covers,
3 Remove residual abraded material from the machine,
e.g. using a brush.
4 Re-attach covers and screw tight.
9.2
Changing the grinding belt
Change the grinding belt if it has become blunt. (Interval:
approx. 100 – 150 grinding operations).
Replace the polishing wheel as follows:
Figure 9.2 – Grinding arm
[1] Fastening screws
[2] Right-hand side panel
1
2
Advertising