Adjusting the water tank, Dismantling the water tank, 6 controls on the belt grinder – Dick SM-140 UltraSharp 230V User Manual
Page 20
Belt grinder SM-140
20
Putting into operation
7
Adjusting the water tank
The quantity of water on the grinding belt is controlled by turning
the eccentric [2].
1 Turn the star handle of the eccentric so that the water tank
swings upwards. The water level should just touch the belt
and therefore wet the grinding belt with water.
2 After using the machine, swing the water tank [4] back
downwards.
Dismantling the water tank
1 To empty and clean the water tank, pull out the conical fixing
bolt [3] while at the same time turning it by hand.
2 Immediately before the next use fill the water tank up to the
marking indicated inside the tank, insert and adjust.
7.6
Controls on the belt grinder
Figure 7.5 – Switches
[1] Switch for switching off (red, 0)
[2] Switch for switching on (green, I)
1