Checking the wiper blades, 292 maintenance – FORD 2013 Edge v.1 User Manual

Page 292

Advertising
background image

If the battery has been disconnected or a new battery has been installed,
the clock and the preset radio stations must be reset once the battery is
reconnected.

Note: Always dispose of automotive batteries in a responsible manner.
Follow your local authorized standards for disposal. Call your local authorized
recycling center to find out more about recycling automotive batteries.

Because your vehicle’s engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:

1. With the vehicle at a complete stop, set the parking brake.

2. Put the gearshift in P (Park), turn off all accessories and start the engine.

3. Run the engine until it reaches normal operating temperature.

4. Allow the engine to idle for at least one minute.

5. Turn the A/C on and allow the engine to idle for at least one minute.

6. Drive the vehicle to complete the relearning process.
• The vehicle may need to be driven 10 miles (16 km) or more to

relearn the idle and fuel trim strategy.

Note: If you do not allow the engine to relearn its idle trim, the idle

quality of your vehicle may be adversely affected until the idle trim is
eventually relearned.

If the battery has been disconnected or a new battery has been installed,
the clock and radio settings must be reset once the battery is reconnected.

CHECKING THE WIPER BLADES

Run the tip of your fingers over the edge of the blade
to check for roughness.

Clean the wiper blades with washer fluid or water
applied with a soft sponge or cloth.

292

Maintenance

2013 Edge (edg)
Owners Guide gf, 1st Printing
USA
(fus)

Advertising