FORD 2013 Taurus v.1 - Manual (Page 171)

2. Press the same button twice to confirm the change to Programming
mode. If done properly the LED light will appear red.
3. Hold the transmitter within 1–3 inches (2–8 cm) of the HomeLink
௡
button.
4. Press and hold the both the programmed Genie button and the
HomeLink
௡ button you want to program. The HomeLink௡ LED will flash
rapidly when the programming is successful.
Note: the Genie transmitter will transmit for up to 30 seconds. If
HomeLink
௡ does not program within 30 seconds the Genie transmitter
will need to be pressed again. If the Genie transmitter LED displays
green and red, release the button until the LED turns off before pressing
the button again.
Once HomeLink
௡ has been programmed successfully, the Genie
transmitter must be changed out of program mode. To do this:
1. Press and hold the previously programmed Genie button for
10 seconds. The LED will change from red to red and green.
2. Press the same button twice to confirm the change. If done correctly
the LED will turn green.
Programming HomeLink ா to the Genie Intellicodeா garage door
opener motor
Note: You may need a ladder to access the garage door opener motor.
To program HomeLink
௡ to the
garage door opener motor.
1. Press and hold the PROGRAM
button on the Garage door opener
motor until both blue LED’s turn on.
2. Release the PROGRAM button.
Only the smaller round LED should
be on.
3. Press and release the program
button. The larger purple LED will
flash
Note: The next two steps must be completed in 30 seconds.
Universal Garage Door Opener 171
2013 Taurus
Owners Guide gf, 1st Printing
USA (fus)