FORD 2011 Explorer v.1 - Manual (Page 121)

Switch
position
1 2 3 4 5 6 7 8 9 10 11 12
Up, on
or +
L L L L L L L L L L L L
Middle,
neutral
or 0
M M M M M M M M M M M M
Down,
off or –
R R R R R R R R R R R R
L=left; M=middle; R=right
3. To input these positions into the
Car2U
௡ system, simultaneously
press all three Car2U
௡ system
buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U
௡ system by pressing and releasing the
buttons corresponding to the settings you circled.
4. After inputting switch settings, simultaneously press and release all
three Car2U
௡ system buttons. The indicator lights will turn on.
5. Press and hold the Car2U
௡
system button you would like to use
to control the garage door.
Immediately (within 1 second)
release the button once the garage
door moves. During this time the
selected button indicator light will
blink slowly. Do not release the
button until you see the garage door move. Most garage doors open
quickly. You may need to hold the button from 5–55 seconds before
observing movement of the garage door.
Driver Controls
120
2011 Explorer (exp)
Owners Guide, 1st Printing
USA (fus)