Driving – FORD 2011 Explorer v.1 User Manual

Page 316

Advertising
background image

WARNING: Just prior to the system recognizing a blocked
condition and alerting the driver, the number of missed objects

will increase. To help avoid injuries, NEVER use the BLIS

௡ as a

replacement for using the side and rear view mirrors and looking over
your shoulder before changing lanes. BLIS

௡ is not a replacement for

careful driving and only an assist.

Once the blockage is removed, the system will require some driving time
and detection of at least two vehicle objects prior to resetting or the
driver can cycle the ignition key. If, however, blockage is still present
after the key cycle, the system will sense again that it is blocked after
driving in traffic.

The following table lists possible causes and actions for this message
being displayed:

The surface of the radar is dirty
or obstructed in some way

Clean the fascia area in front of the
radar, either side, or remove obstruction.

The surface of the radar is not
dirty or obstructed

Drive normally in traffic for a few
minutes to allow the radar to detect that
it is no longer blocked. Note: The
vehicle must be in D (Drive) and a few
vehicles must pass so that the BLIS

௡ can

clear a blocked state.

Heavy rainfall or heavy snowfall
is interfering with the radar
signals

No action required by the driver. The
system will automatically reset to an
unblocked state once the
rainfall/snowfall rate decreases or stops.
Do not use BLIS

௡ and/or CTA in heavy

rainfall or heavy snowfall.

Due to the nature of radar technology, it is possible to get a blockage warning
and not be blocked. This is rare and known as a false blockage warning. A
false blocked condition will either self clear or clear after a key cycle.

Trailer tow false alerts

When towing a trailer, the sensors may detect the trailer thus causing a
false alert. It may be desirable to turn the BLIS

௡ off if the false alerts

become annoying.

Day and night brightness

The BLIS

௡ and/or CTA alert will automatically dim when the headlamp

switch is in PARK, ON, or AUTO ON and night time darkness has been
detected by the sun sensor.

Driving

315

2011 Explorer (exp)
Owners Guide, 1st Printing
USA
(fus)

Advertising