If you want to reset the network setting, Error notification message, P123 – Canon HDMI SX800 User Manual
Page 123
123
Setting an IP Address (SX80)
Operati
ng
the Projec
tor
over Network
6
Click [Apply], and then click the [OK] button when the "Save and apply settings. OK?"
message appears.
This completes the IP address setting of the projector.
■If You Want to Reset the Network Setting
1
Access to the projector from a web browser by referring to the step 1 on "Setting the
Error Notification Message (
).”
2
Click [Initialize] in the network setting screen (
3
Click the [OK] button when “Initialize network settings?” message appears.
To restore the settings with the projector operation, execute [Network setting initializa-
tion] from the menu.
■Error Notification Message
If errors occur in the projector, the following messages are sent.
Error list
* Contact your Canon dealer.
Errors related to
temperature
Error name
Temperature abnormality
Text
The temperature inside the projector is too high for some
reason or the outside air temperature is higher than the
specified one. If the problem is inside the projector,
check whether the projector is installed and operated
normally, turn off the projector to cool its inside, and retry
projection. If the same warning occurs again, the projec-
tor may be defective. Contact your dealer.
Errors related to
the lamp
Error name
Faulty lamp
Text
The lamp has burnt out. Replace the lamp with a new
one. If the same warning occurs again, the lamp drive
circuit may be defective. Contact your dealer.
Errors related to
the lamp cover
Error name
Faulty lamp cover
Text
The lamp cover is open. Check whether the lamp cover
is installed properly. If it is installed properly, the lamp
cover detection switch may be defective. Contact your
dealer.
Errors related to
the cooling fan
Error name
Faulty cooling fan
Text
The cooling fan or another component may be defective.
Contact your dealer.
Errors related to
the power supply
Error name
Faulty power supply
Text
The voltage of part of the power supply is abnormally
high or any other problem has occurred in the power
supply. Contact your dealer.
Other types of
errors
Error name
Unknown Error
Text
Codes in hexadecimal numbers*