Canon HDMI SX800 - Manual (Page 18)

Safety Instructions
18
Position the projector in a horizontal position. Incorrect installation may cause
troubles and accidents.
• Do not tilt the projector more than 20
degrees above and below the horizontal.
• When you want to use your projector point-
ing up or down, make sure to place the pro-
jector straight up or down.
Do Not Use in the Following Environments
• Do not place the projector on an unstable or slanted surface. The projector
may fall causing a personal injury.
• Do not place it in an oily, smoky, or damp location (e.g., near a cooking table
or a humidifier). It may cause a fire or an electric shock.
• Place the projector with a minimum distance of 1 m (3.3') from its left, right,
rear, and top panels to the neighboring object such as a wall. Otherwise, it
may damage the projector due to bad exhaust ventilation.
• Do not put anything near the exhaust vent that may deform or deteriorate
due to heat.
• Do not install the projector in a humid or dusty location or a position where
there is a lot of oily or cigarette smoke. Optical parts such as a lens and mir-
ror may be stained, resulting in poor picture quality.
• Do not place it near an exhaust outlet of air-conditioning equipment. Other-
wise, it may be damaged.
If the projector is carried from a cold place to a warm place or the room tem-
perature is raised rapidly, condensation may form on the lens and mirror due to
the moisture in the atmosphere, resulting in a blurred picture. Wait until con-
densation evaporates and normal picture is shown.
Do not use the projector in a place subject to either very high or very low tem-
peratures. Doing so may cause malfunction. The ranges of the operating and
storage temperatures are as shown below:
Operating temperature: +5°C to +35°C (Humidity: 85% or below)
Storage temperature: -10°C to +60°C (Humidity: 90% or below)
Using the Projector at 2300 Meters or More Above Sea Level
• If you use the projector at 2300 meters or more above sea level, the special
configuration is required to cool down the projector properly. Contact your
dealer.
Caution
20°
20°