Hudson Robotics Micro10x - Manual (Page 17)

17
Adjust Prime Position – This allows the user to jog the dispensing manifold to the
position where they would like all priming functions to occur. When you click on
the button you will be asked if you want to move to the location. If you are
unaware of where the location is, click no and work from the home position
(Figure 2.7.3). After making an adjustment in any of the fields press “OK”. To
lose the changes press “Cancel” (Figure. 2.7.4). The tips should sit ~1/4” into the
trough and be closer to the front of the trough so you do not kink the tubing
coming from the pump fitting. (Figure 2.7.5)
Figure 2.7.3