Hudson Robotics Micro10x - Manual (Page 7)

7
1.3 - Manifold
Install the manifold with the inlet port closest to the pump head. Use the provided
thumbscrews to secure the manifold onto the mounting flange (Figure 1.3.6).
Figure 1.3.6
1.4 - External Cables
The Micro10X Comes with a few cables that need to be installed into the rear of
the unit before the unit can be turned on. The first cable is the pump cable, this is
a black coiled cable that has two 90

connectors. The orientation of the cable
does not matter when plugging the cable in. The pump cable is plugged into the
rear of the pump on one side and the other side plugs into the right side connector
on the rear of the MC10X (Figure 1.4.1). The second cable is the controller cable,
this is the black coiled cable that is attached to the controller, this cable will get
plugged into the left side connector on the rear of the MC10X (Figure 1.4.1). The
last cable is the 24VDC power cable that will get plugged into the 4 position
circular receptacle located on the right side rear panel of the MC10X (Figure
1.4.1).
Note: The MC10x should only be operated with the supplied cables, no substitution is
allowed unless replacement cable is supplied by Hudson Robotics.
Thumbscrews