Hudson Robotics RapidWash - Manual (Page 23)

23
Section 3 - Maintenance of the RapidWash Manifold
3.1 - Removal and Installation of the Manifold
The RapidWash is shipped without the manifold assembly attached to the unit.
The manifold assembly is shipped with a shipping bracket to protect the tips. This
shipping bracket must be removed before the Manifold assembly can be installed onto the
RapidWash. The Manifold assembly has a quick disconnect fitting that holds the
Manifold (Figure 27).
Figure 27
The side of the manifold has two locating holes that allow the manifold to slide onto the
two locating pins on the manifold mount (Figure 28).
Manifold Quick
Disconnect Fitting