Contec Flexlan PC Card FX-DS-110-PCC - Manual (Page 21)

Installation of a driver
FX-DS110-PCC
14
Unplugging the FX-DS110-PCC
The system may run out of control if you unplug the FX-DS110-PCC
with Windows 95, 98, or 2000 running without following the
procedure below. If your PC is under Windows NT 4.0, shut down
the PC before unplugging the PC Card.
(1) In Windows, open the Start Menu and select “Settings” and
then “Control Panel”. Double-click on the “PC Card” icon in
the Control Panel
(2) On the “Socket Status” sheet in the “PC Card Properties”
dialog box, select “CONTEC FX-DS110-PCC” and click on
“OK”.
(3) When the confirmation message has appeared, unplug the
FX-DS110-PCC. Wait for a while until the message appears.
Warning
Handle the unplugged PC Card with care as it may be hot.