Contec Flexlan PC Card FX-DS-110-PCC - Manual (Page 30)

Installation of a driver
FX-DS110-PCC
23
Installing for Windows 98
(1) Windows 98 detects the FX-DS110-PCC as a new piece of
hardware at startup and invokes the “Add New Hardware
wizard” with its dialog box.
(2) Select “Search for the best driver for your device”, then click
on “Next”.
(3) In the search location select dialog box that appears, check
“Floppy Disk Drives” and “Specify a location”. Insert the
"Driver Disk #1" floppy disk into the floppy disk drive, specify
the drivepath as follows, then click on “Next”.
A:\
(4) Make sure that the CONTEC-FX-DS100-PCC driver will be
searched for, then click on “Next”.
(5) When prompted with the message " Please Insert the disk
labeled Windows 98 CD-ROM and then click OK ", follow the
instruction and click on "OK".
If your PC is a Windows preinstalled machine without the
Windows 98 CD-ROM bundled, specify the following path in
the hard disk. This procedure assumes the hard disk drive as
drive C.
C:\WINDOWS\OPTIONS\CABS
(6) If the message " The xxx file in the Windows 98 CD-ROM
could not be found " is displayed during copying of files,
specify " A ". If this message is displayed, specify the path to
the Windows 98 CD-ROM or the path in (5) above.
(7) When copying files has been completed, click on “Finish” to
finish installing the driver, then restart Windows. Set up the
network depending on the operating environment.