Cabletron Systems EMM-E6 - Manual (Page 14)

Chapter 2: Controls and Indicators
2-2 EMM-E6 Installation Guide
Reset Switch
The recessed reset switch re-initializes the EMM-E6 processor. The
activation of this switch will not initialize Non-Volatile Random Access
Memory (NVRAM) where the EMM-E6 stores configuration and
management parameters. The reset switch may be pressed with the point
of a pencil or pen. Once pushed in, the EMM-E6 will re-initialize itself.
LANVIEW LEDs
The EMM-E6 incorporates the LANVIEW status monitoring and
diagnostic system. LANVIEW LEDs can help diagnose many problems,
such as a fault in network cabling. LANVIEW LEDs are identified in
Section 2.3,
LANVIEW LED S .
EPIM (Ethernet Port Interface Module) Slot
The EPIM slot is a covered opening in the EMM-E6 faceplate that can be
configured with an optional EPIM module.
Serial Ports
The EMM-E6 faceplate provides two serial communications ports for the
connection of out-of-band management devices.
BRIM (Bridge/Router Interface Module) Slots
The BRIM slot is a covered opening in the faceplate that can be
configured with a BRIM module.
2.2 INTERNAL COMPONENTS
The components listed in the following entries are all hidden inside the
MMAC chassis when the EMM-E6 has been installed. These components
may be located by removing the EMM-E6 from the chassis and holding
the module in the orientation shown in Figure 2-2 and Figure 2-3.
ICH1Book Page 2 Tuesday, August 6, 1996 3:06 PM