Cabletron Systems EMM-E6 - Manual (Page 54)

Appendix B: Upgrading the EMM-E6
B-4 EMM-E6 Installation Guide
B.3.2 Installing SIMMs
The EMM-E6 uses an angle-down slot (where the SIMM rotates down to
a horizontal locked position). Installing a SIMM in any slot is a simple
two-step process. After finding the proper SIMM slot location
(Figure B-3), refer to the procedures below.
1. Insert the SIMM between the connector teeth in the SIMM slot.
2. Pivot the SIMM down until it locks into the clips in the SIMM slot,
and the SIMM holes fit over the SIMM slot posts. (See Figure B-4.)
Figure B-4 Installing a Horizontal SIMM
!
C AUT IO N
Observe all antistatic precautions when handling sensitive
electronic equipment.
SIMM
Clips Connector
Teeth
SIMM Slot
SIMM Hole
SIMM Slot
Post
1
2
Alignment Notch
1926n18
ICH1Book Page 4 Tuesday, August 6, 1996 3:06 PM