Cabletron Systems EMM-E6 User Manual
Page 22
Advertising
Chapter 3: Installation
3-2
EMM-E6 Installation Guide
3. Carefully remove the module from the shipping box. Leave the
module inside its non-conductive bag until you are ready to install it.
4. Visually inspect the non-conductive bag. If there are any signs of
damage, contact Cabletron Systems Technical Support immediately.
5. Place the static grounding strap properly upon your wrist before
opening the non-conductive bag.
6. Open the non-conductive bag by tearing the black and yellow tape
seal.
7. Perform a second visual inspection of the module.
!
C AUT IO N
Do not cut the bag open, as damage to the EMM-E6 may
result.
ICH1Book Page 2 Tuesday, August 6, 1996 3:06 PM
Advertising