Cabletron Systems EMM-E6 - Manual (Page 23)

Setting Mode Switches
EMM-E6 Installation Guide 3-3
3.2 SETTING MODE SWITCHES
A bank of dip switches, located at the top of the EMM-E6 (Figure 3-1),
provides several configuration options. All switches ship in the OFF
position.
Figure 3-1 EMM-E6 Dip Switches
Never adjust switch settings while the EMM-E6 is on. Not only
is this dangerous, but the change in state (i.e., position) only
activates the switch function after restarting or cycling power to
the board.
LSI
Logic
LSI Logic
A L C O G D S O 8 S ON
1 2 3 4 5 6 7 8
1926n05
Off
On
ICH1Book Page 3 Tuesday, August 6, 1996 3:06 PM