Dell POWEREDGE M1000E - Manual (Page 497)

Fabric OS Command Reference 469
53-1002746-01
ipAddrShow
2
ipAddrShow
Displays IP address information for a switch or control processor (CP).
SYNOPSIS ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot [-eth0 | -eth1 | -gate
DESCRIPTION Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the command
without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on
a chassis.
On a standalone switch, the command displays the following information:
•
Ethernet IP Address
•
Ethernet Subnet mask
•
The Gateway IP Address
•
Dynamic Host Control Protocol (DHCP): on or Off
•
IPv6 Autoconfiguration Enabled: Yes or No
•
Local IPv6 Addresses
•
IPv6 Gateway address
•
DHCPv6: on or off
On modular platforms, the command displays the following information:
For the chassis:
•
Ethernet IP Address
•
Ethernet Subnet mask
For each CP:
•
Ethernet IP Address
•
Ethernet Subnet mask
•
Host Name
•
Gateway IP Address
If the IPFC network interface is configured for logical switches:
•
IPFC address for Virtual Fabric ID
For each CP:
-
Backplane IP address
-
IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays:

All local IPv6 Addresses
 Gateway IP addresses for both CPs
Local IPv6 addresses display the following identifiers:
•
IP Address type:
-
static - A statically configured IPv6 address.
-
stateless - Acquired through stateless autoconfiguration.
•
IP Address state: