Dell POWEREDGE M1000E - Manual (Page 772)

744 Fabric OS Command Reference
53-1002746-01
portErrShow
2
portErrShow
Displays a port error summary.
SYNOPSIS porterrshow
DESCRIPTION Use this command to display an error summary for all ports. Counts are reported on frames transmitted
by the port (Tx) or on frames received by the port (Rx). The display contains one output line per port.
Numeric values exceeding 999 are displayed in units of thousands (k), or millions (m) if indicated.
Values for the following parameters are displayed:
frames tx
Number of frames transmitted (Tx).
frames rx
Number of frames received (Rx).
enc in
Number of encoding errors inside frames received (Rx).
crc err
Number of frames with CRC errors received (Rx).
crc g_eof
Number of frames with CRC errors with good EOF received (Rx).
too shrt
Number of frames shorter than minimum received (Rx).
too long
Number of frames longer than maximum received (Rx).
bad eof
Number of frames with bad end-of-frame delimiters received (Rx).
enc out
Number of encoding error outside of frames received (Rx).
disc c3
Number of Class 3 frames discarded (Rx). This counter includes the sum of the
following class 3 discard counters reported by the portStatsShow command:
er_rx_c3_timeout, er_tx_c2_timeout, er_c2_dest_unreach, and
er_other_disc. Refer to portStatsShow help for a description of these counters.
link fail
Number of link failures (LF1 or LF2 states) received (Rx).
loss sync
Number of times synchronization was lost (Rx).
loss sig
Number of times a loss of signal was received (increments whenever an SFP is
removed) (Rx).
frjt
Number of transmitted frames rejected with F_RJT (Tx).
fbsy
Number of transmitted frames busied with F_BSY (Tx).
c3-timeout tx
The number of transmit class 3 frames discarded at the transmission port due to
timeout (platform- and port-specific).