Dell PowerVault MD3260i - Manual (Page 267)

• Create the required disk group size using other unassigned physical disks.
• Delete the current disk group and then recreate the disk group with the desired number of physical disks.
• Reduce the segment size being used and then retry the operation.
Set Disk Group Forced State
Description
This command moves a disk group into a Forced state. Use this command if the start diskGroup import
command does not move the disk group to an Imported state or if the import operation does not work because of
hardware errors. In a Forced state, the disk group can be imported, and you can then identify the hardware errors.
Syntax
set diskGroup [diskGroupName] forcedState
Parameters
Parameter Description
diskGroup Sequence number of the disk group for which to set
properties. You must put brackets ([ ]) around the disk
group number.
NOTE: You can move the physical disks that comprise a disk group from one storage array to another storage
array. The CLI provides three commands that let you move the physical disks. The commands are start
diskGroup export, start diskGroup import, and set diskGroup forcedState. In the
Forced state, you can perform an import operation on the disk group.
Set Disk Pool
Description
This command sets the attributes associated with a disk pool based on the specified parameters.
Syntax
set diskPool
(diskPool=[diskPoolName] | diskPools=[diskPoolName1... diskPoolNamen] |
allDiskPools)
[reservePhysicalDiskCount=reservePhysicalDiskCountValue |
warningThreshold=(warningThresholdValue | default) |
criticalThreshold=(criticalThresholdValue | default) |
criticalPriority=(highest|high|medium|low|lowest) |
backgroundPriority=(highest|high|medium|low|lowest) |
degradedPriority=(highest|high|medium|low|lowest)
userLabel=diskPoolName]
267