Dell PowerVault MD3260i - Manual (Page 336)

Parameter Description
time Displays the current time to which both RAID controller
modules in the storage array are set.
virtualDiskDistribution Displays the current RAID controller module owner for
each virtual disk in the storage array.
summary Returns a concise list of information about the storage
array configuration.
longRunningOperations Shows the long running operations for each disk group
and each virtual disk in the storage array.
The longRunningOperation parameter returns this
information:
• Name of the disk group or virtual disk
• Long running operation
• Status
• % complete
• Time remaining
NOTE: When you save the information to a file, you can use the information as a record of your configuration and
as an aid during recovery.
Show Storage Array Auto Configure
Description
This command shows the default autoconfiguration that the storage array creates if you issue the autoConfigure
storageArray command. To determine whether the storage array can support specific properties, enter the
parameter for the properties when you issue this command. You do not, however, need to enter any parameters for this
command to return configuration information. If you do not specify any properties, this command returns the RAID 5
candidates for each physical disk type. If RAID 5 candidates are not available, this command returns candidates for
RAID 1 or RAID 0. In order to view the RAID 6 autoConfiguration options, you must specify the raidLevel option.
When you specify auto-configuration properties, the RAID controller modules validate that the firmware can support the
properties.
Syntax
show storageArray autoConfiguration
[physicalDiskType=(SAS)
raidLevel=(0 | 1 | 5 | 6)
diskGroupWidth=numberOfPhysicalDisks diskGroupCount=numberOfDiskGroups
virtualDisksPerGroupCount=
numberOfVirtualDisksPerGroup
hotSpareCount=numberOfHotspares
segmentSize=segmentSizeValue
cacheReadPrefetch=(TRUE | FALSE)
securityType=(none | capable | enabled)]
336