Dell Dimension 4700C - Manual (Page 72)

72
Removing and Installing Parts
www
.dell.com | support.dell.com
5 Disconnect the USB cable on the back of the Media Card Reader from the front panel USB
connector on the system board (see page 62).
6 Disconnect the IEEE 1394 connector on the system board (see page 62).
7 Release the cable from the cable routing clip.
8 Press in on the release tabs at each end of the bracket and slide the unit out.
9 Reconnect the cable to the back of the CD drive.
10 Close the computer cover (see page 80).
Installing a Media Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 53.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
release
tabs (2)
USB cable
IEEE 1394 cable
cable
routing clip
bracket