Dell Dimension 4700C - Manual (Page 74)

74
Removing and Installing Parts
www
.dell.com | support.dell.com
9 Press in on the release tabs at each end of the bracket and slide the unit until it clicks in place.
10 Route the USB cable and the IEEE 1394 cable through the cable routing clip.
11 Close the computer cover (see page 80).
Modem
Replacing the Modem
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
Before you remove or install the modem, make sure to disconnect all telephone and network
cables from your computer.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 53.
2 Open the computer cover (see page 59).
release
tabs (2)
USB cable
IEEE 1394 cable
cable
routing clip
bracket