Additional information, Precautions, On operating voltage – Sony DHC-MD313 User Manual

Page 51: On safety, On placement, On installing, On operation, On the speaker system, Notes on mds, Notes on cds

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Precautions

On operating voltage

Before operating the system, cheek that the

operating voltage of your system is identical with
the voltage of your local power supply.

On safety

• The system is not disconnected from the mains as

long as it is connected to the wall outlet, even if
the system itself has been turned off.

• Unplug the system from the wall outlet if it is not

to be used for an extended period of time.
To disconnect the mains lead, pull it out by the
plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

system, unplug the system and have it checked by
qualified personnel before operating it any
further.

• The mains lead must be changed only at a

qualified service shop.

• When you connect the mains lead to mains, even

through the power is off, the system begins
charging for remote and timer functions.
Therefore the surface of this unit become warm,
this is normal.

On placement

• Make sure the system fan is on during use.

Place the system in a location with adequate air
circuration, and do not place a any on the system.

• Place the system in a location with adequate

ventilation to prevent heat build up.

• Do not place the system in an inclined position.
• Do not place the system in locations where it is;

- Extremely hot or cold
- Dusty or dirty
- Very humid
- Subject to vibrations
- Subject to direct sunlight.

On installing

When you move the system, remove the CD or MEX

On operation

• If the system is brought directly from a cold to a

warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player or the MD deck. Should this occur, the
system will not operate properly. Remove the CD
or MDiand leave the system turned on for about
an hour until the moisture evaporates.

• When you move the system, take out any discs.

If you have any questions or problems concerning
your system, please consult your nearest Sony
dealer.

On the speaker system

This speaker svstem is not magnetically shielded
and the picture on TV sets ma\- becomes
magneticalh’ distorted. In sucli a case, turn off the
power of tlie TV set once, and after 15 to 30 minutes
turn it on again.

If there seems to be no improvement,

locate the

speaker svstem further away from the TV set. Also,
be sure not to place objects in which magnets are
attached or used near the TV set, such as audio
racks, TV stands and toys. These may cause
magnetic distortion to the picture due to their
interaction with the system.

Notes on MDs

• Do not open the shutter to expose the MD. Close

the shutter immediately if the shutter opens.

• Wipe the disc cartridge with a dry cloth to remove

dirt.

• Do not expose the MD to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

Notes on CDs

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out.

• Do not use a CD with tape, seals, or paste on it as

this may damage the player.

• Do not use solvents such as benzine, thinner,

commercially available cleaners, or antistatic
spray intended for vinyl LPs.

•Do not expose the CD to direct sunlight or heat

sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild
detergent solution.

51

Advertising