Self-diagnosis, Display, C11/md protected – Sony DHC-MD313 User Manual

Page 53: Cj3/rec error, C13/disc error, C14/disc error, Troubleshooting, General, There is no sound, There is severe hum or noise

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Self-diagnosis
Display

This system has the Self-diagnosis display
function to lot you know if there is a system
malfunction. The display shows a code made
up of three letters and a message alternately
to show you the problem. To solve the
problem refer to the following list. If any
problem persists, consult your nearest Sony
dealer.

C11/MD Protected

The MD is protected against erasure.

■^Remove the MD and slide the tab to close

the slot (page 28)

CJ3/REC Error

Recording is not possible.

■♦Move the system to a stable place and

start recording over from the beginning

The MD is dirty or is scratched or the MD
does not meet the standards.

■♦Change the MD with another one and

start recording over from the beginning.

C13/Disc Error

The MD deck cannot read the disc
information correctly.

-♦Eject the MD once, then insert it again. .

C14/Disc Error

The MD deck cannot read the disc
information correctly.

•♦Change the MD with another one.

■♦Erase all the recorded contents of the MD

using the Erase function on page 39.

Troubleshooting

If you have anv problem using this system,
use the following checklist.

First, check that the mains lead is connected
firmly and that the speakers are connected

correctly and firmly.

Should any problem persist, consult your
nearest Sony dealer.

General

There is no sound.

• Turn VOLUME clockwise.

• Make sure the headphones are connected.

• Check the speaker connections.

There is severe hum or noise.

• A TV or VCR is placed too close to the

system. Move the system away from the
TV or VCR.

"0:00" flashes in the display.

• A power interruption occurred. Set the

clock and timer settings again.

The timer does not function.

• Set the clock correctly.

The remote does not function.

• There is an obstacle between the remote

and the system.

• The remote is not pointing in the

direction of the system's sensor.

• The batteries have run down. Replace the

batteries.

• Do not place the system in locations

where it is near an electric inverter
system.

The display shows a code made up of
three letters and a message

• This system has the Self-Diagnostic

■ function (see "Self-diagnosis Display" ).

Speakers

Sound comes from one channel, or the left
and right volume are unbalanced.

• Check the speaker connections and

speaker placement.

continued 53

Advertising