Using the remote control – Sony DTR-HD1 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
Using the Remote Control
Inserting the batteries
Insert two size AA (R6) batteries (supplied) by matching the +
and - on the batteries to the diagram inside the battery
compartment.
^ Remove the batteries to avoid damage from possibie battery ieakage
whenever you anticipate that the remote control wiil not be used for an
extended period.
Handle the rerrote control with care. Avoid dropping it getting it wet or
pladng it in dired sunlight: near a heater, or inhere the humidity is high.
To begin using the remote, follow the directions below.
1 Select the component that you want to use with the
corresponding FUNCTION button.
The FUNCTION buttons flash to indicate which component the remote
control is set to o[^rate. .
2 Aim the remote control at the component.
3 Press the POWER button of the component to turn it on and
off.
To-control other functions of the component, see the table that
follows on the next page.
ГЙ1 Buttons described in the following table can operate video components other than
the DTV Receiver only if you programmed the remote control and the component
supports the function described. See page 22 for instructions on programming the
remote control.
19