Sony DTR-HD1 - Manual (Page 22)

Digital Television Receiver
Programming the Remote Control
If you have video components other than a Sony brand that you
would like to control with the DTV Receiver's remote control,
use the following procedures to program the remote control.
^ Your component must have infrared (IR) remote control capability in order to be
used yvith the remote control.
1 Turn to "Programmable Codes" on page 24, and find the
three-digit code number for your component. If more than
one code number is listed, use the number listed first to
complete the following procedures.
Ha You'ihust perform step 3 within 10 seconds of step 2, or you must start
. again from step 2.
2 Press CODE SET.
must perform step 4 within 10 seconds of step 3, or you must start
l^ain from step 2. To cancel the operation, press the ENTER button.
3 Press the FONQION button for DBS/CABLE, or TV.
4 Enter the three-digit code number.
5 Press ENTER.
To Check if the Code Number Works
Use the following prbcedure to make sure the code you've
entered works:
1 Aim the DTV's remote control at the component and press
the POWER button that corresponds to that component.
2 For TVs and cable boxes: If the component responds, try the
CH+ and CH- buttons. If the component responds, you're
done.
22