Sony SLV-R1000 - Manual (Page 16)

^ Preparing the Remote Commander/Selecting Language
2 Insert two size AA (lEC designation R6) batteries
with the polarity lined up correctly.
Notes on the handling of batteries
• With normal use, the batteries should last for
approximately six months.
• If you do not use the Remote Commander for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not mix different types of batteries.
Operating the VCR with the Remote Commander
Set the I TV I / IVTRI remote control selector at the top of the
Remote Commander to “VTR”.
if you are using a Sony TV
You can use the VCR's Remote Commander to operate the
TV. When doing this, slide the |TV| / jVTRI remote control
selector to "iTV i". Buttons on the Remote Commander with
a dot (•) on or beside them can be used to operate your TV.
To operate the VCR, return the ITVI / IVtRI remote control
selector to "I VTR I".
How to Use the Remote Commander
When you operate the VCR using the Remote Commander,
point it at the remote sensor located on the VCR. For the
location of the remote sensor, see "Identifying the Parts and
Controls" on page 65.
When using the Remote Commander to change channels on
a cable box, with the VCR’s Cable box control feature turned
on, point the Remote Commander at the VCR, not the cable
box. For best results, separate the VCR and cable box.
Setting the Command Mode
You can select three different positions for the Command
Mode setting.
Note
If you set the COMMAND MODE VTR 1 /2/3 selector on
the VCR to "OFF", you can no longer control this VCR
from any other Sony Remote Commanders.
2 Set the COMMAND MODE VTR 1/2/3 selector on
the Remote Commander to “VTR 3".
3 Set the ITVi / IVTRI remote control selector on
the Remote Commander to "IVTRI”.
SONY
Tvvm »POWER
CD CD
’Ü3’
oALlOSO*
MO-NTOH 'v. I r --------------4 ^1^ EXECUTE
CD ^ y ^ CD
^ —TlMEHFEC-
____ ______________ CLEAP ONOff 0 © © Q O
16 Preparation