Attaching the eac-66 u/v band separator/mixer – Sony SLV-R1000 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
General Setup Information
Attaching the EAC-66 U/V Band
Separator/Mixer (not supplied)
1
Loosen the screws on the antenna connector.
2
Fit the 300-ohm twin lead cable on the UHF antenna
under the screws on the antenna connector.
3
Retighten the screws.
1
Loosen the screws on the U/V band separator/mixer.
2
Fit the 300-ohm twin iead cable on the UHF antenna
under the screws.
3
Retighten the screws.
4
Connect the 75-ohm coaxial cable to the U/V band
separator/mixer.
5
Connect the U/V band separator/mixer to the
VHF/UHF IN plug on the VCR.
64
Additional Information
Advertising