General setup information, Setting the rf unit, Why this setting is necessary – Sony SLV-R1000 User Manual
Page 62: 2 press power, Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General Setup Information
Setting the RF Unit
Why this setting is necessary:
You must set the RF UNIT selector at the rear of the VCR
properly so that your TV can receive the correct signal from
the VCR. Set the selector to CH3 (channel 3) or CH4
(channel 4), whichever is not active in your area.
If you connect a TV, or color monitor equipped with A/V
input jacks, skip this setting.
1
Set the RF UNIT at the rear of the VCR to CHS or
CH4, whichever is not active In your area.
2
Press POWER.
The power indicator lights up on the VCR.
3
Press TV/VTR so that the VTR indicator lights up in
the display window.
4
Check that the TUNER indicator appears in the
display window, then select an active channel in your
area by pressing CHANNEL +/—.
5
Turn on your TV and set it to the channel you
selected in step 1.
Your TV is now tuned to the VCR. Whenever you use the
VCR, set the TV to the preselected channel.
NOTE:
For details on adjusting TV channels, see your TV
instruction manual.
62
Additional Information