Trouble check – Sony CCD-TRV62 User Manual

Page 68

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Trouble check

If you run into any problem using the camcorder, use the following table to
troubleshoot the problem. Should the difficulty persist, disconnect the power source

and contact your Sony dealer or local authorized Sony service facility.

Camcorder

Power

Symptom

Cause and/or Corrective Action

The power is not on.

The battery pack is not installed.

■ *

Install the battery pack. (p. 8)

The battery is dead.

•>

Use a charged battery pack. (p. 6)

The AC power adaptor is not connected to a wall outlet.

->

Connect the AC power adaptor to a wall outlet, (p. 25)

The power goes off.

While being operated in CAMERA mode, the camcorder

has been in Standby mode for more than 5 minutes.

Turn STANDBY down once and then up again, (p. 11)

• The battery is dead.

Use a charged battery pack. (p. 6)

If VF PW-SAVE is set to ON, the picture disappears

automatically when you turn your face away from the
viewfinder (CCD-TRV72/TRV82 only).

Bring your face close to the viewfinder within 1 /2 inch
(1 cm).
Or set VF PW-SAVE to OFF. (p. 29)

The battery pack is quickly
discharged.

The camcorder does not operate when using a battery pack

that is not an "InfoLITHIUM" battery pack.

Use an "InfoLITHIUM" battery pack. (p. 6)

The ambient temperature is too low. (p. 59)

The battery pack has not been charged fully.

Charge the battery pack again, (p. 6)

The battery pack is completely dead, and carmot be

recharged.

Use another battery pack. (p. 60)

Operation

Symptom

Cause and/or Corrective Action

START/STOP does not
operate.

The tape is stuck to the drum.

Eject the tape. (p. 10)

The tape has run out.

Rewind the tape or use a new one. (p. 22)

The POWER switch is set to VTR.

■ *

Set it to CAMERA, (p. 11)

The tab on the cassette is out (red).

■ *

Use a new tape or slide the tab. (p.lO)

Recording stops in a few
seconds. -

The START/STOP MODE switch is set to 5SEC or .

■>

Set it to

A

. (p. 15)

68

Advertising
This manual is related to the following products: