Notes on charging the battery pack, Note on the battery pack – Sony CCD-TRV62 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging and installing the battery pack
To remove the battery pack
Slide the b.itterv pack in the direction of the arrow.
Notes on charging the battery pack
• The CHARGE lamp will remain lit for a while even if the battery pack is removed
anct the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, disconnect the power cord. After about one
minute, reconnect the power corct again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
• When a fully charged baftery pack is insfalled, the CHARGE lamp will light once,
then go out.
Installing the battery pack
(
1
)
Lift up the viewfinder.
(
2
)
Insert the battery pack in the direction of the ▼ mark on the battery pack. Slide
the battery pack down until it catches on the battery release lever and clicks.
Attach the battery pack to the camcorder securely.
2
^
A
V____________________ ___________________________
J
Note on installing the NP-F930 battery pack or battery case
Use the camcorder while lifting up the viewfinder slightly.
Note on the battery pack
Do not carry the camcorder by grasping the battery pack.
8