Troubleshooting, Setting up, Storing memory dialing numbers – Sony SPP-AQ25 User Manual
Page 43: Making calls
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
Troubleshooting
Problem
Cause/Solution
Setting up
The POWER lamp flashes when
the AC power adaptor is
connected or after a power
interruption.
Press any key.
Storing memory dialing numbers
You hear five short error
beeps and cannot store a
memory dialing number.
• Make sure you follow the procedure in storing the
number correctly (page 21).
• Make sure the number (including the tone and
pause digits, if used) is less than 16 digits.
Making calls
You hear five short error beeps.
Extend the antenna of the base unit vertically.
Move the cordless handset closer to the base unit.
Place the base unit away from noise sources (page
12
) .
Return the handset to the base unit for a while.
The TALK/ВАТТ LOW lamp
flashes.
Charge the battery pack in the cordless handset for
12 hours (page 15).
You hear no dial tone.
Make sure the RING ON/BATT SAVE switch is set
to RING ON.
Make sure the telephone line cord is securely
connected to the telephone outlet.
Charge the battery pack in the cordless handset
(page 15).
The telephone is always connected
to the wrong number, or not
connected at all, even when the
numbers you dial are correct.
Make sure the dial mode setting is correct (page
16).
General
39