Notes on the power lamp, The alkaline batteries – Sony CCD-TRV53 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using alternative power sources
WARNING
The power cord must only be changed at qualified service shop.
PRECAUTIONS
The set is not disconnected from the AC power source (mains) as long as it is
connected to the wall outlet, even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use.
This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.
t h e a l k a l i n e b a t t e r i e s
>
Q.
<
a
o
- CCD-TRV32H'RV52/TRV53 only
Use the battery case (supplied) and six size AA (LR6) Sony alkaline batteries (not
supplied).
(
1
)
Remove the battery holder from the battery case.
(
2
)
Insert six new alkaline batteries by matching the + and - on the batteries to
the diagram on the battery holder.
(3)
Insert the battery holder with the alkaline batteries.
(4)
Install the battery case with the alkaline batteries to the battery mounting
surface of the camcorder in the same way as the battery pack.
25