Canon EOS 3000 QD - Manual (Page 55)

Using the Built-in Flash
Built-in Flash Range
(With ef 35-80mm f/4-5.6 lens)
ISO
35 mm 80 mm
Negative Film Reversal Film Negative Film Reversal Film
100 1 -4.2m/3.3-138« 1 -3m/3-3-9,9fl 1 -3m/3.3-9.9ft 1-2.1 m/3.3-69ft
400 1 - 8 4 m / 3.3 - 27 7 « 1.2-6m/3.9-19.8« 1 - 6 m / 3 3 - 1 9 8 f t 1 - 4 2 m / 3 3 - 1 3 , 8 f t
<p> Red-Eye Reduction
When flash is used in a low-light environment, the subject's eyes may look
red in the photograph. “Red eye” happens when the light from the flash
reflects off the pupils of the eyes.
The camera’s red-eye reduction feature uses red-eye reduction lamp to
shine a gentle light into the subject’s eyes to narrow the pupil diameter or
iris. A smaller pupil reduces the chances of red eye from occurring. Red­
eye reduction can be set in any picture-taking mode.
Red-eye reduction
lamp-on indicator
Press the
«S»
button.
• Check that the <<§>> icon appears
on the LCD panel.
• To cancel red-eye reduction, press
the <<§>> button again.
Pop up the built-in flash.
• When you press the shutter button
completely, the red-eye reduction
lamp will light and the picture will be
taken about 1 sec. later.
• The picture cannot be taken while the
red-eye reduction lamp is lit.
0 » The red-eye reduction lamp can also light while an external, EOS-dedicated
Speedlite (EX series) is attached to the camera
• Note that some subjects may be responsive to red-eye reduction while others may not be. •
-:фс
• Red-eye reduction can be effective only when the subject looks at the red-eye
reduction lamp. Encourage the subject to look at the lamp
• To increase the effectiveness of red-eye reduction, make the room brighter or
move closer to the subject
55