Canon Rebel Ti 300V - Manual (Page 56)

Troubleshooting Guide
If there is a problem, try to resolve it by referring to this Troubleshooting Guide. If
the problem still persists, take the camera to your nearest Canon Service Center.
Reference
Nothing is dis­
played on the
LCD panel.
The batteries are exhausted.
► Replace the batteries with new ones, (-^page 14)
The batteries have been installed incorrectly.
► Install the batteries correctly, (^page 14)
The picture
looks blurred.
The lens focus mode is set to
<MF>
(or
<M>).
► Set the lens focus mode to <AF>. (-»page 16)
There was camera shake when the picture was taken.
► Hold the camera steady or use a faster shutter speed,
(-»page 17)
The shutter
does not work.
The frame count is not displayed on the LCD panel.
► Take out the film and load it correctly, (-^page 18)
The < cm > icon blinks on the LCD panel.
•• Replace the batteries with new ones, (-»page 14)
The <@> icon blinks while the rewound film is still in the
camera.
► Replace with a new roll of film, (-»page 18)
The focus confirmation light <•> in the viewfinder blinks
and focus cannot be achieved
► Select another AF point, (-»page 32)
If focus still cannot be achieved, focus manually, (-»page 34)
The < cn >
icon blinks on
the LCD panel.
The battery level is very low.
► Replace the batteries with new ones, (-»page 14)
A misoperation has occurred.
► Press the shutter button halfway, (^page 17)
► Remove the batteries and reload it. (-»page 14)
If the blinking < cm > icon does not turn off, consult
your nearest Canon Service Center.
W When using an external flash unit, an EOS-dedicated Speedlite is recom­
mended. Using the camera with a flash unit (equipped with electrical contacts
on the hot shoe foot), high-voltage flash unit, or flash accessories dedicated
to a different brand may result in camera misoperation or malfunction.
56