Catler JE 8010 - Manual (Page 21)

19 19
TROUBLE SHOOTING GUIDE
POSSIBLE PROBLEM EASY SOLUTION
Machine will not work when
switched “ON” The safety locking arm may not be correctly engaged in the vertical operating position with the locking arm
located into the two grooves on either side of the juice cover (see picture on page 8, step 4).
Motor appears to stall when
juicing Wet pulp can build up under the cover if the juicing action is too vigorous. Try slower juicing action by pushing
the food pusher down more slowly (refer page 11, step 4). Clean the fi lter bowl surround, the stainless steel fi lter
and the juicer cover. Select HIGH speed instead of the LOW speed setting.
Excess pulp building up in the
Stainless Steel Filter Basket Stop the juicing process. Remove the juicer cover (refer page 13-15, steps 1 - 8), scrape off pulp.
Re-assemble (refer page 7-9, steps 1 - 7) and begin juicing again.Try alternating (soft and hard) vegetable and
fruit varieties.
Pulp too wet and reduced
extracted juice Try a slower juicing action. Remove Stainless Steel Filter Basket (refer page 13-15, steps 1 - 8) and thoroughly
clean mesh walls with a fi ne brush. Rinse Stainless Steel Filter Basket under hot water. If the mesh holes are
blocked, soak the Stainless Steel Filter Basket in a solution of hot water with 10% lemon juice to unblock the
holes or wash in the dishwasher. This will remove excess fi bre build up (from fruit or vegetables) which could be
inhibiting the juice fl ow.
Juice leaks between the rim
of the Juicer Cover and the
Stainless Steel Filter Basket Try a slower juicing action by pushing the food pusher down more slowly (refer page 11, step 4).
Fruit and vegetables with a high water content (tomatoes and watermelon) should be juiced on low speed.
Filter bowl Surround Sprays juice
out from spout Try a slower juicing action by pushing the food pusher down more slowly (refer page 11, step 4).
The Unit will not switch on Check the Overload Protection Button on the bottom of the Motor Base to check if the safety device has not been
activated automatically.
TROUBLE SHOOTING GUIDE