Catler JE 8011 - Manual (Page 17)

OPERATING YOUR JE 8011 JUICER
STEP 1
Wash your selection of fruit and/or vegetables
ready for juicing. Prepare fruits according to
charts above.
STEP 2
Based on the type of fruit or vegetable you are
juicing/pureeing select either the Juice Extractor
or the Puree Extractor.
WARNING:
DO NOT PUT HARD FRUIT AND VEGETABLES
(IE. CARROTS, APPLES, FRESH BEETROOT,
ETC.) OR ICE THROUGH JUICER WHEN USING
PUREE EXTRACTOR. THIS COULD DAMAGE
PARTS OF THE UNIT.
STEP 3
Ensure the JE 8011 Juicer is correctly assembled
– see previous instructions. Ensure the Juice
Extractor or Puree Extractor is thoroughly
cleaned before each use (refer to cleaning on
pages 26–27). Ensure you place the Juice Jug (or
glass) under spout before commencing juicing.
STEP 4
Plug the power cord into a 230/240V power
outlet and then turn the power on at the outlet.
The light surrounding the “START | STOP” button
will illuminate.
NOTE:
The light will be illuminated for 2 mi-
nutes before fading into sleep mode.
The light will come back on by activat-
ing any of the controls.
STEP 5
Use the speed selector table as a guide for juicing
different fruit and vegetables. Push the “START |
STOP” button and the unit will automatically
start.
STEP 6
With the motor running, place food into the
Feed chute Using the Food Pusher, gently guide
food down the Feed Chute. Do not exert excess
pressure. To extract the maximum amount of
juice, always push the Food Pusher down slowly.
STEP 7 – USING THE JUICE EXTRACTOR
As fruits and vegetables are processed juice will
flow into the juice jug and the separated pulp
will accumulate in the Pulp Container.
The Pulp Container can be emptied during
juicing by turning Juicer “OFF” at the control
panel and then carefully removing the Pulp
Container. Replace the empty Pulp Container
into position before continuing to juice.
NOTE:
Do not allow the Pulp Container to over
fill as this may affect the operation of
appliance.
17 17
OPERATING YOUR JE 8011 JUICER
WITH JUICE EXTRACTOR OR PUREE EXTRACTOR