Catler JE 8011 - Manual (Page 18)

18
OPERATING YOUR JE 8011 JUICER
STEP 8 – USING THE PUREE EXTRACTOR
When using the Puree Extractor puree will flow
into the juice jug. There will be no pulp extracted
into Pulp Container.
NOTE 1:
SELF-RESET OVERHEATING
PROTECTION
The JE 8011 Juicer also fitted with a self-
resetting safety device which safeguards
against overheating on the motor with
excessive loads. If overheating occurs,
the juicer will automatically activate the
overheating protection device and the
motor will switch itself off. If this occurs,
the light surrounding the “START | STOP”
button will flash red. When the over-
heating protection is activated, unplug
the juicer from power outlet for at least
15 minutes to allow the unit to cool.
Then plug juicer into the power outlet
and use as normal.
NOTE 2:
ELECTRONIC PROTECTION
The JE 8011 Juicer will automatically
stop operating if the motor is stalled.
This is an electronic safety feature. Ei-
ther too much food is being processed
at one time or the pieces are not small
enough. Try trimming food, cutting food
into smaller pieces of even size and/or
processing a smaller amount per batch.
If this occurs, the light surrounding the
“START | STOP” button will flash red.
To continue juicing, turn the power
“OFF” at the power outlet, clear the feed
chute, finally turn the appliance back on
by pressing the “START | STOP” button
to “ON”.
NOTE 3:
OVERLOAD PROTECTION BUTTON
The JE 8011 Juicer is fitted with a safety
device which safeguards against over-
loading with excessive loads. If this oc-
curs, juicer will automatically activate
the overload protection button and the
unit will switch itself off.
If this occurs turn the power “OFF” at the
power outlet and allow the unit to cool.
Then press the Overload Protection But-
ton found on the bottom of the Motor
Base. The safety device will then be reset
and the JE 8011 Juicer is ready for use
again.