BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 10)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 10 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
43. Zip tie factory ECU plug so there is proper clear-
ance with out wire chaffing or rubbing.
44. Install Torque building silicone air box, make
sure not to slide on to far for proper jackshaft clear-
ance. Tighten hose clamps.
NOTE: if installing inner-cooler see next step.
45. Install silicone hose onto throttle body adapters
make sure to have proper jackshaft clearance
IF NOT installing inner-cooler go to step#49
46.Install Torque building inner-cooler, (Tech tip,
moving steering post may make install easier.) Adjust
for clearance from cylinder head, electrical wiring,
fuel filter, fan, and chassis before tightening.
47. Locate the A/C PWR plug, (A/C plug is located
in Velcro pouch above the fan near steering post.
Plug the fan booster into the factory A/C plug, and
rubber connector into fan. 48. Install the fan onto the inner-cooler using the sup-
plied 1/4” bolts and lock washers. Route the fan wire
harness to fan booster and secure w/ zip ties.