BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 13)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 13 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
61.Using a 3” hole saw drill a 3” hole in the hood.
62. Install the aluminum pipe on the intake elbow,
secure with a hose clamp. Install air filter on the pipe
outside the hood and secure with supplied hose
clamps
63.Using the supplied Turbo oil fill the oil level to
the top of line of (F) witch represents full .
Note : do
not over fill, as it will push out of the oil tank vent.
Oil tank hold aprox 12oz.
64. Reinstall-Fuel Tank, seat and Hood . Attach the
control box using supplied Velcro Route the Boost
pressure line from the control box to the push to con-
nect fitting on the Air box or Cooler.
65.Install the Clutch Kit , Primary spring, and clutch
weights, Install Secondary spring and Helix. Rec-
ommended helix start: 40-46-36, if less RPM desired
42-48-36 Faster up shift. 66.Start the Snowmobile to verify that the oil pump
has power and the oil pump is pumping oil, when
verified install the oil fitting on the turbo and tighten
down.