BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 8)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 8 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
31. Install turbo inlet and v-band clamp do no tighten
all the way, make sure it is properly aligned, seated
and snug v-band clamp.
32. Install stainless muffler into tunnel and attach to
turbo using v-band clamp make sure to properly
align, seat, snug v-band do not tighten all the way.
33. Install Tial external waste gate, rotate turbo inlet
and muffler for proper alignment using supplied
clamps snug waste gate into place do not tighten yet.
34. Spring turbo inlet into place using the 4 long gold
exhaust springs.
35. Spring muffler into place using short exhaust
spring. (At this time finish riveting the kick plat in
place, use inside rivet to adjust distance between
muffler and kick plate) 36. Make sure there is no binding in exhaust connec-
tions and the are no gaps between V-band connec-
tions
(NOTE: gaps will not close by tightening.)
Tighten all V-band and waste gate clamps