BoonDocker POLARIS: 2011-14 PRO RMK 800 - Manual (Page 6)

BoonDocker RMK Turbo
Revised 11/5/2012 Page 6 of 13
www.boondockers.com……………….....
BoonDocker
……….………………....877-522-7805
19.Remove pipe and exhaust donut. Silicone both
sides of donut to ensure proper seal to Y-pipe and
Pipe.
20. Spring pipe to Y-pipe using stock and supplied
springs, double up springs on all spring tabs, this will
prevent a boost leak.
(Note: if sled is not building
proper boost check donuts for seal)
21.Remove small exhaust donut and run a bead of
silicone on inside and seal to the end of the pipe.
22. Run a bead of silicone on the bell of the turbo
inlet pipe.
23.Install turbo flange gasket between turbo and inlet
and bolt in place using the 4 supplied bolts and top
lock nuts.
24. Spring inlet into place using the 4 long exhaust
springs. Install springs long side towards pipe so
springs do not touch.