BoonDocker SKI-DOO: 2013-14 XM E-TEC 800 - Manual (Page 10)

Revised 12/28/2012 Page 10 of 10
www.boondockers.com………………..... ……….………………....877-522-7805
49.Install the hose from ECM on to cold air in-
take box. Install the hose clamp on the cold air
bracket & tube. Test fit the head light & tighten
the hose clamp. As seen in picture. 50.Install the silicone hose on the cold air intake
box tube then install the tube with no hose
clamps. Install the hose & clamps between the
cold air intake tube & turbo. As seen in picture.
51.Install the head light assembly. Route the
control box as seen in picture. Clean the console
& install Velcro. Heat the glue on the Velcro to
activate. 52.Remove primary clutch. Remove the old
ramps. Install roll pins in ramps, index roll pins
as seen in picture. (perform clutch adjustments
to Ski-Doo specifications)
53.Install the pins in the clutch. At the top of the
page is low elevation to 5,000ft clutching. At the
bottom is 5000 ft up clutching. Tighten the set
screws to cotter pins in both cases. 54.Fill the turbo oil tank with12oz of TC2 Turbo
oil. Remove the oil feed line off of the turbo
start the snow machine verify oil flow. Install
the oil line & tighten.